SB Acoustics MR16P-4 "Satori" 6" Midrange - 4 Ohm

• Vented aerodynamic cast aluminium chassis for optimum strength and low compression.
• Proprietary cone material with EGYPTIAN PAPYRUS™ fibres made in-house.
• Soft low damping rubber surround for optimum transient response.
• Advanced BIMAX spider for improved linearity.
• Powerful optimized low distortion neodymium motor system.
• Non-conducting fibre glass voice coil former for minimum damping.
• Extended copper sleeve on pole piece for low inductance and reduced distortion.
• CCAW voice coil for reduced moving mass.
• Long life silver lead wires attached 180° apart for improved stability.
• Vented pole piece and coil former for reduced compression.
• High piston to chassis diameter ratio.
• Gasket and bolt hole protrusions for reduced coupling to speaker cabinet.
• Mode balanced cone for reduced break-up.

Enclosure Recommendation:
0.15 - 0.20 cubic foot sealed and filled with damping material for an F3 of 110 Hz. You will most likely be crossing this midrange over higher than this natural roll-off.

Datasheet - Satori MR16P-4